Jump to content

hand polished edges


Neil

Recommended Posts

My latest rack is holding water and seems good .But with a 200mm gap between the tanks and 850 to the back wall I'll have to stick my head and neck in between the top edge of one tank and the bottom edge off the tank above.

So after $10 and some diamond sharpening stones plus elbow grease. Polished edges on 12mm and while I was at it the vertical edge and the corner got a good balling off.Cheap and a good finishing off to a long project. Just need to sort the lids and make removable side drops .

Neil

Link to comment
Share on other sites

  • 2 weeks later...

Protect his head??

If you are jamming your head between tanks there is a chance that the edges may be sharp. Most tank builders will remove the sharp edges using emery cloth or another abrasive but this is not always the case.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...